How to Use:
Function Principle:
- Make sure that vapors from cleaning agents or disinfectants have evaporated before turning on the device.
- Do not block or cover the air vents during use or cooling down.
- Check that the mouthpiece and cooling unit are clean and free of obstructions.
- Inspect both the vaporizer and the power supply for visible damage before use.
- Confirm that the voltage on the rating plate matches the local power supply.
- Fully charge your device before first use.
- Do not leave the vaporizer unattended during operation. In case of malfunction, immediately unplug the power adapter from the socket.
Turning on:
Press and hold the orange power switch (ON/OFF) for at least half a second.
The device vibrates briefly and begins heating up to the factory-set base temperature of 180°C / 356°F.
Turning off:
Press the power switch (ON/OFF) again for at least half a second.
The device confirms shutdown with a vibration.
► Always allow the device to cool down completely before storing it.
💡 The brightness of the MIGHTY+ display is fixed and cannot be adjusted.
For safety, the device has an automatic shutdown function.
If no activity is detected within the default shutdown time, the vaporizer automatically turns off.
► Please note that weak draws may not be detected, but pressing any button resets the shutdown timer.
💡 More information about this feature is included in the user manual.
The MIGHTY+ has small feet on the bottom that provide basic stability on flat surfaces.
For additional stability while filling, you can use the Filling Chamber Tool as an extra support:
- Remove the tool from the housing.
- Rotate it so that it protrudes outward and acts as a support.
- Reinsert it.
► The device is now stable.
Start vaporizing after the heating process is complete.
- Flip out the mouthpiece of the cooling unit.
- Place the mouthpiece between your lips.
- Inhale evenly for a few seconds, but only half as much as you actually can.
- Hold your breath for a few seconds, then exhale slowly.
- Focus consciously on the breathing process.
💡 The more intense the vapors, the stronger the taste may be affected.
No or too little vapor
- Clean the cooling unit and filling chamber as described in the user manual under the chapter "Cleaning".
- After cleaning, remove the cooling unit and cover the air inlet with your finger.
Inhale through the mouthpiece:
► If airflow still exists, the cooling unit may be leaking and should be replaced.► If the problem persists, consider initiating an RMA repair by registering your device.